The filter press can be used to give you a look at what your drilling fluid is doing in the borehole. By testing your drilling fluid with the filter press, you get to see what your actual fluid loss numbers are, as well as seeing how your filter cake is performing downhole. What you want is a thin, tight filter cake, that, when measured on the filter paper, is under 1⁄16 of an inch thick to be considered acceptable. Record what the fluid loss is in cubic centimeters. You also will want to record what the properties of the fluid are on the filter cake – such as its softness, slickness, firmness, sponginess, flexibility, etc.
The picture with the comparison of two different drilling fluid filter cakes
shows the one on the left is a thick, ineffective filter cake that had
high fluid loss with poor rheology. This can be from drilling just using the
native clays you encounter in the borehole, or using a poorly yielded sodium
bentonite with poor make-up water, and not using soda ash with your bentonite.
The one on the right is what you want to see in your drilling fluid – a thin,
tight filter cake with very little fluid loss in the 30-minute
High fluid loss on a drilling project can become a major expense to the
contractor, especially if you have to run a tanker truck away from the job site
for additional water in order to continue drilling. The thick filter cake also
can lead to other problems, such as swabbing the hole as you trip out with your
drill stem and bit. This swabbing action creates a suction that can pull the
hole shut behind you, as the borehole integrity and stability has been
compromised with the drilled formation being saturated with excess
One way to reduce your fluid loss and tighten up the filter cake is with the
use of a PAC polymer. PAC is an acronym for polyanionic cellulose, which, when
mixed with a high-quality sodium bentonite, creates a thin, tight filter cake
with superior low-fluid-loss numbers. PACs come in both liquid and dry form.
They also are available in standard formulas and low-viscosity formulas to keep
your drilling fluid viscosity lower to help with drilling rig pump performance
and penetration rates. Be sure to us the PAC according to the manufacturers’
specifications in order to get the best performance out of the product you are
The filter press can be a helpful tool to see what is going on downhole with
your drilling fluids. By taking advantage of the testing tools and the
bentonite, polymers and additives available for the various drilling conditions
you will encounter, you are well prepared for a successful drilling project.
Drilling Fluids: For a Window down the Borehole, Try a Filter Press
May 1, 2012